It all started with a protractor that stabbed me in the hand while trying to measure 55 degrees while setting up two mics for a ORTF configuration. I used my 3D printer to start making different microphone mounts during Covid, while also teaching myself electrical engineering to make one of a kind pedals that are NEVER clones of something that already exists. The world does not need another Klon clone or PT2399 delay, bleh.

So we promise that our products will never be boring and will always be something unique and special. Also EVERY pedal we sell uses at least one recycled part, and usually quite a bit more. I try to use as many Carbon Composition resistors as I can get my hands on and yes I know they vary widely in variance. I’ve seen some 40% out of spec! But I literally check the value of everything that is put in one of my pedals and I never go more than 5% out of variance.